Skull Pumpkin Stencil

A skull that glows: shave the bone, cut the sockets, nose and tooth slots, and the cut parts burn brightest.

Tones
Carving
Size and paper

Drawing the stencil…

A shaved skull with cut-out features

This skull is shaved, not cut out: the whole skull is gray on the stencil, so you shave the skin and a sliver of flesh off the whole skull shape, and it glows a warm orange with the eye sockets, nose and tooth gaps shining bright through it. Try the Lit pumpkin view: it shows how much brighter the cut parts are than the shaved bone.

Medium gives a skull about 5.5 inches wide and 6 inches tall, which fits one page, with eight holes and no bridges.

Order of work

  1. Prick through the paper along the skull’s edge and around each hole.
  2. Cut the eye sockets and the nose first, then the five slots between the teeth. Cut them while the skin around them is still on: a shaved wall is thinner and cracks more easily.
  3. Score the outline of the skull, including the jaw, and shave inward.
  4. Scrape the inside wall behind the skull as thin as you safely can. The thinner it is, the brighter the shaved skull glows.

If a tooth breaks

The teeth between the slots are strips of shaved pumpkin, held at the top and bottom. If one snaps, pin it back with half a toothpick pushed in from the side. Wider teeth are stronger, so for a soft pumpkin pick a bigger stencil size instead of the smallest one.

For more scary designs, see the scary pumpkin stencils.

The design on this page

DesignDifficultyTonesWhy
SkullMediumCut and shaveMore pieces or curves; may need a bridge or a shaved area

All designs were drawn for this site. Every other design is one click away under All in the picker, and the pumpkin stencil maker also turns photos into stencils.

Pumpkin Stencil MakerSomeone shared their result

Embed Pumpkin Stencil Maker

Free on any site or board. Pick where it goes, and paste what it gives you.

Where will you put it?

    Theme, size and a live preview

    Suggested